Bitmain Antminer E9(2.4Gh) FAQs

To help you understand the Bitmain Antminer E9(2.4Gh) miner, we’ve listed some frequently asked questions about it.

What Cryptocurrencies Can I Mine With Bitmain Antminer E9?

E9 now supports mining ETC after updating to the most recent firmware from the official website.

What Mining Pools Does Bitmain Antminer E9 Support?

The following popular mining pools are supported by E9 after updating to the most recent Antminer E9(2.4Gh) firmware.

f2pool.com
ethermine.org
2miners.com
ezil.me
hiveon.net
richpool.pro
poolin.com
pool.btc.com
binance.com
antpool.com

NOTE*: Three mining pools cannot be set up to operate with different cryptocurrencies simultaneously.

Does Bitmain Antminer E9 Support Zil+ETC Mode Mining?

Zil+ETC mining requires mining pool support and is not connected to the miner.

Does Bitmain Antminer E9 Support Nicehash Mining Pools?

No, E9 ONLY supports the most popular pools using the eth proxy stratum protocol (for example, it DOES NOT support ETH stratum protocol with extra hash or nice hash by now). f2pool, antpool, hiveon, ethminer2, etc. )

The Bitmain Antminer E9 Rejection Rate is Very High, Why Does It Reach 50% Or 100%?

There may be a computing board failure with a rejection rate of about 50%, the mining pool side having only 50% of the arithmetic power. If this is the case, you can reinsert the platoon to restore factory settings, upgrade the firmware, and perform other routine operations to try; if this is unsuccessful, the majority of them must be sent back for repair.

Check to see if the mining pool is configured with ETHW or ETHF, then switch to an ETC mining pool and restart. The rejection rate is at 100%, the miner has arithmetic power, but the pool does not.
NOTE*:Three mining pools cannot be set up to operate with different coins simultaneously.